rsThe enable acceleration option isn't listed at all. Why?
Board is a DZ68VZ
RST RAID driver version 12.6
RAID 1 volume is consistent with no errors and is in continuous update mode.
I have looked for a list of reasons why the UI would fail and haven't found anything. Is there a utility that can examine the system and provide the reason why acceleration is not an option?
This is my RAID volume:
Description Disk drive
Manufacturer (Standard disk drives)
Model Intel Raid 1 Volume SCSI Disk Device
Bytes/Sector 512
Media Loaded Yes
Media Type Fixed hard disk
Partitions 2
SCSI Bus 0
SCSI Logical Unit 0
SCSI Port 2
SCSI Target ID 1
Sectors/Track 63
Size 931.50 GB (1,000,194,048,000 bytes)
Total Cylinders 121,600
Total Sectors 1,953,504,000
Total Tracks 31,008,000
Tracks/Cylinder 255
Partition Disk #0, Partition #0
Partition Size 100.00 MB (104,857,600 bytes)
Partition Starting Offset 1,048,576 bytes
Partition Disk #0, Partition #1
Partition Size 901.37 GB (967,835,648,000 bytes)
Partition Starting Offset 105,906,176 bytes
This is the new SSD I am trying to add:
Description Disk drive
Manufacturer (Standard disk drives)
Model INTEL SSDSC2CT180A4 SCSI Disk Device
Bytes/Sector 512
Media Loaded Yes
Media Type Fixed hard disk
Partitions 1
SCSI Bus 5
SCSI Logical Unit 0
SCSI Port 2
SCSI Target ID 0
Sectors/Track 63
Size 167.68 GB (180,043,153,920 bytes)
Total Cylinders 21,889
Total Sectors 351,646,785
Total Tracks 5,581,695
Tracks/Cylinder 255
Partition Disk #1, Partition #0
Partition Size 167.55 GB (179,909,427,200 bytes)
Partition Starting Offset 135,266,304 bytes