Good afternoon.
I recently attempted a bios flash for a DH61WW and it seems to have gone bad! 
The original bios was version 0020 and I wished to take it to the latest release. Having succesfully flashed another board recently (dh61cr) I'd learned that I'd need to do this in stages (ie flash to 0099 before on to the latest).
So, as 0020 would not support the use of F7, I used succesfully the intergrator toolkit to flash to 0046. I had initially tried 0099 but the toolkit could not open it. I'd had the same issue when flashing the dh61cr. So anyway, I copied the 0099 to a sandisk usb, and used F7 to perform the Flash. It went through its motions without any error reported.
However upon its restart, the new (usually fullscreen) logo appeared centrally on screen, then the logo jumped to the left of the screen (still central vertically) and there it hangs.... no boot.
I now have the following symptoms:
1) As above on power on system hangs with the logo shifting to the left. No response from Keyboard
2) If quick enough, tapping F2 will load the bios screen. From here I see the bios version is 0099. I can move around the bios, make changes, save them etc. However upon reboot, system hangs as in 1)
3) Can load F7 and can navigate to and select file to flash from (0099, 0046) and get to the stage where it asks to choose "enter" to continue, but system hangs at this point, any attemp at reboot results in the hang at 1)
4) Can load F12 to select boot device, system just hangs.
I have tried:
Removing cmos battery.
Removed jumper completely to attempt recovery.... nothing on screen.
I really would appreciate some help to recover the PC, and thank you in advance for any ideas/advice you have.
Regards
Phil